[dryadsoul]

Yes, Sir, the aluminum is for 3" riser fan shrouds to go in push/pull array with 4 Panflo 115cfm 38x120mm fans attached to that dual core '77 poncho HC. And diamond has the highest thermal conductive rate at the costliest price ...........besides being the most difficult to cut! Pure absurdity that!

I'm fairly certain my system will pull aproximately 22°C idle/34°C load temps before full tweak of setup is complete. Toying with a concentric dual metal canister reservoir design........must work out best method of bonding the copper inside to the aluminum outer shell........silver solder would seem ideal???? Possibly apply push/pull air as well.

At any rate I need to purchase new camera Nicads so that I can start intended indepth system construction/install log. Thanks again for the battery reminder, perhaps that's why I have procrastinated my auto parts trip to this point.

System will maintain full ½" barb integrity throughout with Zero elbows and nylon braided 3/4"OD tube with 200psi @ 75°/100psi @ 150° & a 2"ID coil bend rate. Overkill security that at only 98centavo per foot!!!!

On the rebound & AwraBest