I was just reading this thread:
Quote:
Re: GA-EP35-DS3L vcore problem after Standby
--------------------------------------------------------------------------------
Well yes, and no. 2.1 is likely for sure all your ram needs, but with the proper timings as well. If you dont want to mess with tweaking it for a while then I would suggest you use 2.2 and please do you ram a favor and put a fan over it.
You will need a RMA soon for sure with 2.2, that is the MAX warrantied voltage, not what is needed to run stable.
I would suggest this for 4x1GB >>>
Performance Enhance = [Standard]
CAS Latency Time________________ 4
Dram RAS# to CAS# Delay_________ 4
Dram RAS# Precharge Delay_______4
Precharge Delay (tRAS)__________ 12
Start with the higher settings, moving later ONE AT A TIME lower and test after each move
ACT to ACT Delay (tRRD)_________ 3-4
Rank Write to READ Delay________ 9-11
Write to Precharge Delay_________ 3-5
Refresh to ACT Delay______________ 42-52
Read to Precharge Delay__________ 3-6
Static tRead Value_______________ 7-10
Static tRead Phase Adjust________ Auto << Leave ALWAYS
System Voltage Control____ [Manual]
DDR2 OverVoltage Control__ [+0.3V]
PCI-E OverVoltage Control_ [Normal]
FSB OverVoltage Control___ [+0.1V]
(G)MCH OverVoltage Control [+0.1V - 0.15V]
|
Do you think :
1. Performance Enhance setting should be listed in this guide too???
2. Does Refresh to ACT Delay settings depend upon memory capacity??? 2,4 or 8gigs.
3. Should System Voltage Controls concerning memory also be included in this guide???