[Lsdmeasap]

So nice to see you are now stable!!

So what are you asking? You want some ram timings or .....?

I see you are overclocking your CPU already so I just was not sure what you meant you wanted suggestions for

I would try these for what you are running now >>>

Robust Graphics Booster___________ [Auto]
CPU Clock Ratio ____________ [8]
CPU Host Clock Control_ [Enabled]
CPU Host Frequency (MHz)__________ [444] << I think that is what you are using?
PCI Express Frequency (Mhz)_______ [100]
C.I.A. 2__________________________ [Disabled]
System Memory Multiplier (SPD)____ [2.40]
DRAM Timing Selectable_______ SPD __ [Manual]

Performance Enhance = [Standard]

CAS Latency Time________________ 5
Dram RAS# to CAS# Delay_________ 5
Dram RAS# Precharge Delay________5
Precharge Delay (tRAS)__________ 15

These are ranges, use the higher first then move lower one at a time while testing between each move with Memtest86+

ACT to ACT Delay (tRRD)_________ 3-4
Rank Write to READ Delay________ 9-11
Write to Precharge Delay_________ 11-14
Refresh to ACT Delay______________ 48-50 (52-62)
Read to Precharge Delay__________ 3-6
Static tRead Value_______________ 7-10
Static tRead Phase Adjust________ 1-31 << Do not adjust, leave at Auto or Zero or 1-31

System Voltage Control____ [Manual]

CPU/PCIEX Clock Driving Control [800mV]
CPU Clock Skew Control [150ps]
GMCH Clock Skew Control [250ps]

DDR2 OverVoltage Control__ [+0.300V] = 2.1v You may have good/better luck with using 2.0V actually with these sticks

FSB OverVoltage Control___ [+0.1V]
(G)MCH OverVoltage Control [+0.1V - +0.15V]