Thanks Max, I am new at these gaming boards and and I have to admit it is a little daunting. I am sure there is nothing wrong with the board, its just something I am missing. Here are my RAM timings
Newegg.com - G.SKILL 4GB (2 x 2GB) 240-Pin DDR2 SDRAM DDR2 1066 (PC2 8500) Dual Channel Kit Desktop Memory - Desktop Memory
Cas Latency: 5
Timing: 5-5-5-15
Voltage: 2.1V
Heat Spreader: Yes
I have not updated the BIOS, its a brand new board from Newegg. If possible thats the last thing I want to try. I was thinking of clearing the CMOS becuase I believe that is where these setting are saved to. But I have not tried that either, I was hoping it was something I jsut missed, like I said it worked the first time I went to 3.4GHz, but then backed off a little and I can change it again, the host clock controller disables itself after the reboot. Its got the Rev 1.3 and I do not have ACHI enabled on this board. I believe the CIA2 is set to Auto but I will check. Thanks for any help my friend. If I could just get the Host Clock controller to hold a setting it would work. I am lost I tell you. LOL. Thanks.