I have a hp a6750f. It has Vista on it. I partition the drive and installed XP pro on it SP3. It is now dual boot. In XP everything works except the SM Bus Controller has a yellow ?!. Can anyone please help me out with the drivers I need to install to get this functioning properly? Also, I am no computer guru by any means.
Thanks in advance,
jeff
| Motherboard description | - Motherboard manufacturer's name: MSI MS-7548
- HP/Compaq name: Aspen-GL8E
|
| CPU/Processor | - Socket AM2+ supports AM2, AM2+ processors
- Memory support is limited to DDR2 modules
- Supports the following processors:
- AMD Phenom Quad-Core 9xxx series (AM2+)
- AMD Phenom Triple-Core 8xxx series (AM2+)
- Athlon X2 BE-2xxx (AM2)
- Athlon 64 X2 with Dual Core technology
|
| Front-side bus (FSB) (Processor Dependent) | - Up to 5200MT/s (5.2 GT/s) when using compatible AM2+ or AM3 processor
|
| Chipset | |
| BIOS features | - Keyboard combination used to enter BIOS: F10
- System BIOS core brand: Award
|
| Form factor | - Micro-ATX: 9.6 in x 9.6 in
|
| Memory | - Dual channel memory architecture
- Four DDR2 SO-DIMM (240-pin) sockets
- Supported DIMM types:
- PC2-6400 (800 MHz)
- PC2-5300 (667 MHz)
- Non-ECC memory only, unbuffered
- Supports 4GB DDR2 DIMMs
- Supports up to 16 GB on 64-bit PCs
- Supports up to 4 GB* on 32-bit PCs
| NOTE: | *Actual available memory may be less |
|
| Expansion slots | - One PCI Express x16 graphics (for a graphics card)
- Three PCI Express x1 (for cards such as network, sound, tv-tuner)
|
| Video graphics | - Integrated graphics using ATI Radeon™ HD 3200 (Supports DirectX® 10)
- Supports concurrent use of dual displays connected to onboard DVI-D and VGA connectors.
- Also supports PCI Express x16 graphics cards as independent graphics adapters.*
| NOTE: | *Either integrated graphics or a discrete graphics card are usable at one time; they are not usable concurrently.. |
|
| Serial ATA |
- Supports 1 SATA-150 or SATA-300 disk drive on each SATA connector
- Speed up to 3.0Gb/sec or 1.5Gb/sec, complying with SATA 2.0 and SATA 1.0 specifications
| NOTE: | The faster rate of 3.0Gb/sec requires that both the hard drive and the motherboard support it. If one or the other does not support 3.0 Gb/sec, the system negotiates down to the slower 1.5 Gb/sec. |
|
| RAID | Ready to use. - Starting Spring09, CTO models in North America may be configured for:
- RAID pass-through
- RAID 0
- RAID 1
- For all other regions, this motherboard ships in RAID Pass-Through mode. This means it is ready to be configured for RAID 0 or RAID 1.
- RAID modes supported:
|