07-03-2009, 05:31 AM
|
 |
Senior Member
|
|
Join Date: Apr 2009
Location: J'Habite En Angleterre
Posts: 1,822
|
|
Re: Can't get 3.6Ghz with E6600/EP45-UD3P
Clock drive settings of 700/700 = failsafe defaults. This may have happened if you flashed the BIOS recently, then forgot to load optimized defaults, save and exit afterwards.
I'd load optimized defaults right away, re-enter most of your settings but try Lsdmeasap's recommendations. PLL is ok up to 1.61V.
__________________
Lian Li PC-A09 Case (Full Aluminium)
Corsair HX750 (CWT, 91%(80+ Gold rated @230V) single 62A 12V rail
EP45-UD3P v1.0 @ F10e
E7400 @ 9.5 x 411, 3.9GHz, 1.425v ??c idle (stuck DTS sensors) and 57c full load (23c ambient)
TRUE Black with a single Noctua NF-P12 pumping out 55 CFM @ 19db .
2x2GB Corsair XMS2 PC2-8500, @ 5-5-5-15, 1093-DDR, 2.14v tRead 7 stable
2 x HD4850 512MB @ 715 Core / 2130 Mem. CrossFireX
Scythe Musashi twin 100mm fan cooler, 40c Idle and 65C FurMark "Xtreme Burning Mode"
Intel X25-M 80GB SSD (OS and Programs) 250MB/s Read 75MB/s Write and WD Caviar Blue 640GB (Storage, Downloads, Temp Files & Folders, Page File etc)
Noctua 1300RPM 19dB case fans
Dell Ultra Sharp 2209WAf E-IPS @ 1680x1050
This rig loads Windows 7 from the end of AHCI detection to a usable desktop in 13 seconds. 
System has passed 24 Hours Prime Blend, 12 hours of both Large and Small FFT and 50 Runs of Intel Burn Test (Maximum Stress)
http://valid.canardpc.com/show_oc.php?id=609332
|