Ask and ye shall receive. These are my current test settings, survived 1 hour of Orthos so far.
If I didn't list it, assume it's set to Auto. And yes, my RAM timings suck, not concerned with those right now.
Code:
*************************************
*************************************
Gigabyte GA-EP45-UD3P (Rev. 1.1) - F7
E8400 C0
GSkill F2-8500CL5D-4GBPK 2x2GB
*************************************
*************************************
******************************
MB Intelligent Tweaker(M.I.T.)
******************************
Robust Graphics Booster ..............: [Auto]
CPU Clock Ratio ......................: [7X]
x Fine CPU Clock Ratio................: +0.0
CPU Frequency ........................: 3.73GHz (533x7.0)
********** Clock Chip Control ********
>>>>> Standard Clock Control
CPU Host Clock Control................: [Enabled]
x CPU Host Frequency(Mhz).............: [ 533]
PCI Express Frequency(Mhz)............: [102]
C.I.A.2...............................: [Disabled]
>>>>> Advanced Clock Control..........: [Press Enter]
CPU Clock Drive.......................: [800mV]
PCI Express Clock Drive...............: [900mV]
CPU Clock Skew........................: [ 0ps]
MCH Clock Skew........................: [ 0ps]
******** DRAM Performance Control ********
Performance Enhance...................: [Standard]
Extreme Memory Profile(X.M.P.)........: [Auto]
(G)MCH Frequency Latch................: [Auto]
System Memory Multiplier (SPD)........: [2.00D]
Memory Frequency(Mhz).....1066.........: 1066
DRAM Timing Selectable (SPD)..........: [Manual]
>>>>> Standard Timing Control
x CAS Latency Time................5...: [5]
x tRCD ...........................5...: [ 5]
x tRP.............................5...: [ 5]
x tRAS...........................15...: [ 15]
>>>>> Advanced Timing Control.........: [Press Enter]
x tRRD............................4...: Auto
x tWTR............................4...: Auto
x tWR.............................13..: Auto
x tRFC...........................68...: Auto
x tRTP............................4...: Auto
x Command Rate (CMD) .............0...: 2
>>>>> Channel A Timing Settings.......: [Press Enter]
x Static tRead Value..............11...: [ 10]
>>>>> Channel B Timing Settings.......: [Press Enter]
x Static tRead Value..............11...: [ 10]
****** Motherboard Voltage Control ******
Voltage Types..........Normal...........Current
-----------------------------------------------
>>> CPU
Load-Line Calibration.................: [Disabled]
CPU Vcore..............1.27500V.......: [1.4000V] (CPUZ and HW Monitor both report 1.36 in Windows)
CPU Termination........1.200V.........: [1.380V]
CPU PLL................1.500V.........: [1.730V]
CPU Reference..........0.760V.........: [Auto]
>>> MCH/ICH
MCH Core...............1.100V.........: [1.340V]
MCH Reference..........0.760V.........: [0.834V]
MCH/DRAM Reference.....0.900V.........: [1.210V]
ICH I/O................1.500V.........: [1.570V]
ICH Core...............1.100V.........: [1.300V]
>>> DRAM
DRAM Voltage...........1.800V.........: [2.100V]
DRAM Termination.......0.900V.........: [Auto]
Channel A Reference....0.900V.........: [Auto]
Channel B Reference....0.900V.........: [Auto]