Z68 Pro3-M V2.3 worst yet how do I go back to V1.x?

[paul666]

I would not have thought it possible but 2.3 represents a new low.

Here I am talking about the on-board graphics using HDMI (primary) and DVI:

2.3:
Post only displayed on DVI – No good it’s not my primary mon.
Plus all faults listed below.

2.2:
5 Beeps at boot if nothing in the VGA dsub.
PC no longer works with a power saver socket I used to plug it into to turn off other devices when I turned off the PC. Now it randomly causes these other devices to turn off & then on again – PC is on the entire time.

1.6 (ish):
BIOS displayed incorrectly on HDTVs see attached pic.

V2.x has stuffed my PC can I go back to v1.x?

I see in the change notes that you keep making changes for ‘Improve discrete VGA card vBIOS compatibility’; is there any chance at all the you could fix the on-board graphics that have not worked correctly since 1.6 (ish if ever) and have now in V2 reached a new lower?

[paul666]

Bump