Case Modding Gallery!

**Devilishdanny** · 12-13-2002

Thanks for that.

:thumb:

**Wiggo** · 12-14-2002

As some of ya may know my old K6-3+ server finally decided it would refuse to work till it had a rebuild so here it is runnin' on the workshelf ( :laugh: ) while I write this post with it. :)

**Wiggo** · 12-14-2002

Yep an old AT board there but I forgot to take the before shots of the case but here it is after a clean up and replaced the front 80mm intake fan with a 120mm one plus filtered all 3 intake fans.

**Wiggo** · 12-14-2002

A rear shot. ;)

**E^vol** · 12-15-2002

Nice filters Wiggo, where did you get them ?:?:

**Wiggo** · 12-15-2002

I got them from Jaycar which is an Australian/N.Z. electronics store and the 80mm cost $4.75aus with the 120mm at $4.95. ;)
<center>:cheers:</center>

**AMD2NR** · 12-18-2002

Thats a sweet case wiggo!!! Looks like you shouldnt have any trouble keepin' your good ol' K6-3 properly chilled... LOL. Did they even make server boards for the K6-3 with RAID for server setups?

**Wiggo** · 12-18-2002

Sadly no they didn't make any such boards and the K6-2/3/+ are all MP capable as well. :(

As for keepin' the K6-3+ 450MHz cool well it's a bit of a job while it's tickin' over at 560MHz under full load 24/7. :D
<center>:cheers:</center>