RAID 0 Status Failed on BIOS Change
Hi all, I just ran into a strange issue.
I was experiencing some temp issues with this board, so was trying diff setups to check. As part of this I reset my RAM timings to SPD and saved the setup in BIOS. After reboot, I got a disk read error and BIOS says reboot the system.
Tried several times, nothing happened, then I realised that my RAID was not showing in the post screens... I went into the BIOS and surely enough, the SATA RAID/AHCI was not set ! I didn't touch this setting, so not sure why or how it got changed in the BIOS.. Anyway, I set it back to RAID and tried rebooting. This time the RAID shows up after detecting device on port 2 and 4, but the status of the RAID shows "Failed"...
If I enter the config screen the following is displayed
ID - 0
Name - SpecRAID
Level - RAID0(Stripe)
Strip - 128KB
Size - 465.8GB
Status - Failed
Bootable - No
Physical Disks:
Port Drive Model Serial # Size Type/Status(Vol ID)
2 ST3250410AS 6RY...... 232.9GB Non-RAID Disk
4 ST3250410AS 6RY...... 232.9GB Member Disk(0)
Can anyone help with this please ? Is there anyway to recover from this ?
__________________
Intel Q6600, Zalman CNPS 9700LED, Gigabyte GA-X38-DQ6
Gigabyte nVidia 8800GTX
2GB Corsair Twin2X PC-8500 DDR2 5-5-5-15 @1066
2 x Seagate Barracuda 250GB SATAII NCQ GB RAID0
Samsung 244T
Creative Fatal1ty Keyboard, Razer Diamondback
Logitech G25 Racing Wheel, Creative Inspire T7900
Thermaltake Toughpower 750W & Kandalf with 25cm side panel fan
Windows Vista Home Premium 32
-------------------------------------------------------------------------------------------------------------
Small print - All suggestions I give on this forum are just that - Suggestions.
I'm merely suggesting an approach/opinion which I would have taken - Try at your own risk.
|
Linear Mode
