Gigabyte GA-EX58-UD5 + KHX2000C9D3T1K3/6GX

EivindS · #1 (**permalink**) 10-16-2009, 11:36 PM

I am having problems with configuring my memory to run at 2000mhz. With the "auto" settings it runs at 1066mhz.. I have read that a lot of people are having this problem.

Can someone please tell me how to configure this to run properly at 2000mhz:

Gigabyte GA-EX58-UD5
2x Kingston DDR3 HyperX T1 2000MHz 6GB (KHX2000C9D3T1K3/6GX)
Intel Core™ i7 Quad Processor i7-950 - 1366, 3.066GHz

**Lsdmeasap** · #2 (**permalink**) 10-16-2009, 11:53 PM

Please see here, no need to make three threads unless no one was helping you out :)
Gigabyte GA-EX58-UD5 + KHX2000C9D3T1K3/6GX

EivindS · #3 (**permalink**) 10-16-2009, 11:58 PM

Sorry about that, I just tough maybe different people where reading different "areas" .. :)

**Lsdmeasap** · #4 (**permalink**) 10-17-2009, 12:20 AM

There is but you may have been waiting on a reply for a while in other sections.

cytec · #5 (**permalink**) 10-28-2009, 05:08 PM

I am having the exact same issue with a similar hardware setup. I've been reading the UD5 manual, but man, this bios is crazy!

Specs:
i7 920 d0 stepping
Kingston Hyperx 2000 3x2gb
Gigabyte UD5 mobo

It boots at 1066, as the OP originally stated. If anyone has a writeup on how to obtain those speeds, that would be great! Thanks,

matt

**Lsdmeasap** · #6 (**permalink**) 10-28-2009, 05:11 PM

Getting 2000Mhz will be a bit tough for you to do at first. Have you tried to get 1600Mhz going?

I can help but there is no write up anywhere that I know of. If you need help get a template from my signature and give me your full current settings and I will advise you how to go about trying 1600 and 2000

Thread Tools
Show Printable Version Email this Page
Display Modes	Rate This Thread
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode	Rate This Thread:

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)