KHX8500D2K2/2GN Set up and preformance

[nagonsa]

Hello to everyone, sorry for my english, I will try my best.
I have a board type EP45-UD3r rev. 1.1 and 4 kingston KHX8500D2K2/2GN Hyper X. I have had some blue screen shot several times while running some games and some programas. I have check into the Kingston web page and it looks like this memory is not listed to be sopported by this board, but in the board manual it says you can use 1066 x 4 gb.
I have looked into bios and my settings are not also the same as web page of kingston says. I should put 5-5-5-15 and change the voltage to 2.2 or should I leave it in auto which says 6-6-6-18 and a voltage of 2.1?
I have only changed the timings to 5-5-5-15 and seems it works correct, but i will like to have it as good as I can for good preformance, i do not want oc or something similar. Can someone help with the settings on the Bios? Should leave all in auto or should I change values?
Thanks and sorry again for my english.

[kromar]

i have the 2x2gb rams so not sure if this helps... i also had stability problems and i tested every value for stability so here is my final setting for the ram:

Set Memory Clock ............. [Manual]
Memory Clock ................. [x5.33] 1066Mhz

DRAM Configuration
DCTs Mode .................... [Unganged]
DDRII Timing Items ........... [Manual]
CAS# latency ................. [5T]      
RAS to CAS R/W Delay ......... [5T]       
(tRP)Row Precharge Time ...... [5T]        
Minimum RAS Active Time ...... [15T]   

1T/2T Command Timing ......... [2T]        
TwTr Command Delay ........... [4T]      

Trfc0 for DIMM1 .............. [105ns]

Write Recovery Time .......... [8T]
Precharge Time ............... [3T]
Row Cycle Time ............... [20T] 
RAS to RAS Delay ............. [4T] 

DDR2 Voltage Control ......... (+0.200V)  2.06V

[nagonsa]

Thanks very much Kromar, but I think it is solved. I have post some info into Gigabyte board and they have told me to change timings and voltage, and now it seem to work correct.
Thanks Kromar...