Gigabyte X38/P35/P965 (DS* DQ* S3) Overclocking and General BIOS tweaking Guide

[Lsdmeasap]

It controls the FSB voltage, the Vtt we cannot control, and is probably in AUTO which is likely a good thing. The higher settings that kill things were people as you see anandtech doing is pushing it way high, something AUTO would not do. Granted I hate AUTO and it is generally to much or not enough it does not ever go TOO HIGH

[Merman]

This link shows an image of the MIT of a Gigabyte X38-DQ6. It has the FSB OverVoltage Control, GLTREF2 Voltage Ratio and Loadline Calibration.






Legion Hardware

[Lsdmeasap]

Yeah, I said I was insure if DQ6 has GLTREF2, nice to see it does. But it does not have Vtt. All GA boards have FSB voltage control, some have loadline.

[jimmyjojo]

Yeah, I said I was insure if DQ6 has GLTREF2, nice to see it does. But it does not have Vtt. All GA boards have FSB voltage control, some have loadline.

this is great to see

[MaxSolidarity]

Hey there, I'm all new to these forums and they seem great - I've spent about 4 hours reading and reading as I'm having some problems with my home built PC at the moment - more on that later perhaps.

I wanted to ask - is this guide generaly recomended for the X48-DQ6 mobo?

I'm using a Q9300 CPU.

I'm assuming it is and have learnt alot and followed the guide for the BIOS settings at stock speeds.

Reguarding my problems: I have a few more things I want to try before I hassle you all for help!

Thanks again!


EDIT 26/08/08
Right, about the problems I mentioned, I located the source of them - a faulty ram stick. I made a video about the MemTest errors because I had not ever seen MemTest behaive in the way it did while the faulty ram stick was i by itself.
for those interested see it here:
YouTube - RAM stick = FAIL

Thanks for all the great forums!
Max Solidarity

[Johnny123]

I've found most of the BIOS settings here are in the P31 BIOS.

[tweekdown]

Hi, is this Guide also applicable to P45 Boards?

[Lsdmeasap]

Yes it is, there is some newer options in P45, but most all is the same. The memory timing names are different though. Please see the pinned memory guide for the shortened names comparision

[FILTHYSCUMBAG]

hahaha. thought i was seeing double. This is the guide I was following, but on the other site it's posted. Very good job the writer did. I WAS using the guide until it got to the section on testing memory using the first 3 tests in memtest. With the settings listed I cannot get my pc to post.

Also, The only Volt left increased is teh DDR2/DDR3, the guide seems to imply it, but it states that the "base" config. with the increased volts is to simply counter the vdroop.

anyway, i'm not sure where to begin since I can't begin that section. I don't feel like spending an hour lowering multiplier by 2 and rebooting until pc posts. The opposite of this is true also. If i lower a lot and increase 3, I could spend way more time than necessary.

suggestions?

[Lsdmeasap]

Yeap, Bill said I could copy it over

Did you read the Memory Sticky I posted here as well, it should get you started. If not make a new thread and I will help you with settings