BSOD Error codes....

[Acebmxer]

BSOD codes for overclocking

X58, P55 Codes

0x101 = increase vcore
0x124 = increase/decrease QPI/VTT
0x0A = unstable RAM/IMC, increase QPI/VTT first, if that doesn't work increase vcore
0x1A = Memory management error. It usually means a bad stick of Ram. Test with Memtest or whatever you prefer. Try raising your Ram voltage
0x1E = increase vcore
0x3B = increase vcore
0x3D = increase vcore
0xD1 = QPI/VTT, increase/decrease as necessary, can also be unstable Ram, raise Ram voltage
0x9C = QPI/VTT most likely, but increasing vcore has helped in some instances
0x50 = RAM timings/Frequency or uncore multi unstable, increase RAM voltage or adjust QPI/VTT, or lower uncore if you're higher than 2x
0x109 = Not enough or too Much memory voltage
0x116 = Low IOH (NB) voltage, GPU issue (most common when running multi-GPU/overclocking GPU)
0x7E = Corrupted OS file, possibly from overclocking. Run sfc /scannow and chkdsk /r
0xF7 = increase/decrease QPI/VTT


BSOD Codes for SandyBridge P67,Z68 and Ivy Bridge Z77

0x124 = add/remove vcore or QPI/VTT voltage (usually Vcore, once it was QPI/VTT)
0x101 = add more vcore
0x50 = RAM timings/Frequency add DDR3 voltage or add QPI/VTT
0x1E = add more vcore
0x3B = add more vcore
0xD1 = add QPI/VTT voltage
“0x9C = QPI/VTT most likely, but increasing vcore has helped in some instances”
0X109 = add DDR3 voltage
0x0A = add QPI/VTT voltage

This is taken from XS Forum. A user there posted this. Thought it would help over here...


If you see any errors please post correction.

Edit - Updated List 10/4/11
Edit - Updated List, and format 1/19/12
Edit - Included Z77 7/1/12

[Acebmxer]

Bump updated list.....

[Lsdmeasap]

Bump for this

Maybe we can keep it up there. I never see any of these on SB, except when Vcore is too low.

[Vinster]

Bump.... this has been very helpful

Vin

[crazy]

I've been looking for a week or so on what the problem was with my pc, and found it here by chance, just before I started formatting a new drive.
My ram timing was reset when I reset bios, fault 0x00000050 thought is was wifi driver ewbusnet.sys as that was always listed on bsod, looks like it's fixed. I just bought a new sata 3 drive too. It's an upgrade from the sata 2 anyway, looks like a ghost job to me.

Thank you very much for this info, saved me a hell of a time, because the same errors would have still happened with the new HDD anyway, I guess.

You guys Rock.

[Vinster]

can this be stickied? I've needed this list a few times in the last few days. I am sure others would appreciate this as much as I have.

Vin

[phillywood]

Thanks for this. I trying to max OC before the winter ends. 4.4 LinX stable, working on 4.45 thanks again.


Cheers

[Acebmxer]

Good luck push it hard.... lets see 4.5ghz stable :)

[phillywood]

Hello 4494mhz. thanks again for your work!

[Acebmxer]

awsome nice work