X58-UD3R Rev 1.0 flashing bios for 3TB Hard Drive

[Oenz]

I have BSOD about Marvell 91xx Config ATA Device since I flash my bios with the F8b...

I don't know what is the version there is in this bios... but I have BSOD with it.

I know I need to update my Windows, or at least Windows will check if there is a update for it. But I can't for now because my Windows aren't active anymore since I flashed the bios (currently unavailable for this weekend, there is no tech support for Windows in the weekend)

[Acebmxer]

While you wait for MS maybe try this modded version of the bios. This bios has been updated with all the latest Roms. Do not flash if you do not have Rev 1 of the board.

X58A-UD3R Rev. 1.0 Bios F8b MOD Complete
Updated with...
IRST 11.5.0.1582
Realteck 2.48
Jmicron 1.07.28
Marvell Bios Version 1.0.0.1033 / Firmware 2.2.0.1125
After flash is complete, shut down fully and switch off PSU, wait one minute and clear CMOS. Then turn on, boot to BIOS and load optimized and save/apply/reboot back to the BIOS. Once in the BIOS again set AHCI settings and Marvell Firmware mode to "Force", then save/apply/reboot and let it load through to windows, before that happens Marvell Firmware will update and board will reboot.*
X58AUD3Rrev1MOD_8_19_12.8b

[Oenz]

Thank you. I'm trying this right now and let you know if I have other BSOD