hey..And HELP...And thanks
i snagged my wifes X 48 DQ6 mobo running a Q-9550 (stock is 2.83) Its never been OCed..
Its replacing my same board running an E 8600 (that now after 8 years fails to OC) stock at 3.33
So..I want to OC this Quad..But it refuses to... Even with a small FSB increase to just run @ 2.95 fails... All stock voltages.. I also tired to run up the CPU voltage slightly to no avail..
Ok..So its all set up in the bios as I have always done.. BUT
I am running a 4 X 2 mem set now, giving me 8 gigs of PC8500.. (old OCZ) before they bit the big one.. STOCK VOLTAGES
Should I increase the mem volts, and where and how much ?
I also read the guide here, and I have never set my PCI to 102...I have always run it at 100. ?
Now..I am no OCing genius, but I have OCed many boards without any problams, so I'm no rookie too..
I currently have a newer E5200 running stable at 3.6 on air... (GO Stepping based off the older Wolfdale)
I think this Quad is a GO stepping..I am not 100% on that though..
What I want to do is pull the water cooling out of my old shop computer and put it on the new X48 and Q9550 , as this Intel 775 idels @ 32-38 on different cores ... I ran Intel burn, completed all passes, and nothing peaked over 42...Soo..Buttt That is on air with a Freezer Pro cooler, running max @ 2700
Any syggestions would make my sorry ass day..lol
And thanks for any help or advice anyone can offer..
BTW...This Q9550 and my old E8600 are both like 7-8 years old.. is it possiable that they are just to cooked to OC now?
I dont want to buy new fesser and tubing for this project if I cant get it to OC..yup..I'm being cheap... My wife said I had to be..,.haha
UPDATE: Was just reading here, and thought it note worthy to mention my PSU.. Its a Therimatake ( I think) 850 W 80+ single rail pushing 72 Amps.. And its also 7-8 years old.. This same PSU also was running my E8600 that just lost its ability to OC.. I do have a new PSU rated at 56Amps on a single rail that i could test with...but..My comp weighs 78Lbs and I hate moving it to my shop ...
Last edited by harleyman; 03-01-2013 at 03:00 AM.
There are currently 1 users browsing this thread. (0 members and 1 guests)