kennett5
Junior Member

have you hit 4.8ghz yet:laughing::tongue02:

yes your right boon,hahha

how come you didn't use pro on the die ace? ive seen another user cover the transistors with a thin cut down strip of electrical tape just to...

that seems a lot better chip ace !!! need to scalp it

I think sin is writing an oc guide and fair few users here have just gone haswell so should help with settings ect if you didn't wanna mess with...

different ram models? seems to be might be better to have a matching kit how much qpi/vtt are you using in bios? might need more idk maybe...

get it,its worth the extra in the long run,ive seen a fair few 4670k and 3570k's using more voltage than the bigger brother hyperthreaded chips,maybe...

well if its the same as ivy in controlling the cpu memory controller stock 1.05v wont be enough for 16gb,it wont adjust on auto you have to manually...

might need a touch more 1.10v cpu ring voltage?? might be where its falling over,esp with 16gb

how much ram? is cpu ring voltage same as cpu/vtt on ivy? @ace hyper threaded chips tend to be the better clockers tbh,seem to need less volts

ive heard uncore be lower than one below cpu multi around 23x for 40x cpu multi

yeah you have to manually set cpu/vtt,1.05v might be too low for 16gb

when you get your new memory enable xmp as it will setup the timings dram voltage,you might need to manually set cpu/vtt from stock 1.05v to 1.10v...

I would flash back to f9,seems to be the best imo could be just pure chance you've had two sticks go bad idk if your enabling xmp for the...

I want to play too :(

have you also disabled onboard graphics (igpu) in the bios? that reserves a portion of memory also enable/disable memory remapping if you have the...

do you have a 32bit windows version? to use the full 8gb you'll need a 64bit version of windows 32bit can make use of 3.5gb maximum memory

just another update,still going strong on f9 final bios,thats after a few days powered off and on for three days solid,does seem to be linked to beta...

pretty sure you press alt and f10 together as fast as you can just as gigabyte splash screen pops up

lets hope more get added inc Samsung green,its not to hard to manually set them up tbh @moths its probably down to poor thermal paste application...

ahh that's good,don't be scared to use upto 1.65v dram voltage,that memory can take it just fine,1.55v tends to be the sweetspot

have you tried pushing the Samsung ram past 2400mhz? the limit was 2300mhz on ib for me,would be interesting to see on haswell,1.65v dram is safe to...

you just need time to allow drivers and bios's to catch up its usually the case with new platforms/chipsets

well they are supposed to resume beta bios/improvements for z77 due to getting z87 ready I hope they can fix all these pain in the arse niggles as...

^^ was that a beta or final bios? been testing now a good four to five days on latest final and its yet to do it,ill soon report back if it does...

what does easytune say? could be software bug idk

yes you can request an rma for each part,psu/motherboard I would just say they are not working,don't mention what you did just incase

ok what you will need cpu-z to monitor cpu voltage/speed cpu-z_1.64.3.zip prime95 to stress cpu...

yes,you'll see a big performance drop compared to running in dual channel,it should work fine in dual channel mode,if not there's an issue somewhere...

yeah try normal,then see what temps/voltages are in windows while stressing the cpu