GA-Z68X-UD3P-B3 no deep power-saving

[bloodmaster]

Hi all

Another promblem i realize with this mobo after the 2 onboard raid controlles (cant work together on raid mode with both enabled), is that do not switch the cpu voltage to deep power-saving mode.
It switch the frequency multi BUT NOT the voltage with the C3/C6 State set in auto and enabled.
I dont use LLC (disabled).



Bios settings

CPU Clock Ratio .....................................:42
CPU Frequency.......................................:4 212Mhz
PWM Frequency Control................................: [Auto]
CPU Over Current Protection..........................: [Auto]
Internal CPU <acronym title="Phase Locked Loop">PLL</acronym> Overvoltage.........................: [Disabled]
Real Time Ratio Changes In OS .......................: [Enabled]
Intel(R) Turbo Boost Tech ...........................: [Disabled]
Turbo Ratio (Core 1).................................: [Auto]
Turbo Ratio (Core 2).................................: [Auto]
Turbo Ratio (Core 3).................................: [Auto]
Turbo Ratio (Core 4).................................: [Auto]
Turbo Power Limit (Watts)............................: [Auto]
Turbo Current Limit (Amps)...........................: [Auto]
CPU Cores Enabled ...................................: [All]
CPU Multi Threading..................................: [Enabled]
CPU Enhanced Halt (C1E) .............................: [Auto
C3/C6 State Support .................................: [Auto]
CPU Thermal Monitor .................................: [Auto]
CPU EIST Function ...................................: [Auto]
Bi-Directional PROCHOT ..............................: [Auto]

CPU
Multi-Steps Load-Line ...........................: [Disabled]
CPU Vcore ...........................................: 1.300v
Dynamic Vcore (DVID)...........................: 0.00v
QPI/<acronym title="Voltage Termination (FSB Termination Voltage)">VTT</acronym> Voltage 1.050v .......................: 1.050
System Agent Voltage 0.925v ................: 0.925v
MCH/ICH
CPU <acronym title="Phase Locked Loop">PLL</acronym> 1.800v ....................................: 1.800v
DRAM
DRAM Voltage 1.500v ...........................: 1.500v
DRAM Termination 0.750v .....................: [Auto]
Ch-A Data VRef. 0.750v ........................: [Auto]
Ch-B Data VRef. 0.750v ........................: [Auto]
Ch-A Address VRef. 0.750v ...................: [Auto]
Ch-B Address VRef. 0.750v ...................: [Auto]

[Chike]

Re: GA-Z68X-UD3P-B3 no deep power-saving

When voltage set manually it cant be changed with power saving options.
Use normal + DVID instead fixed vcore.

[bloodmaster]

Re: GA-Z68X-UD3P-B3 no deep power-saving

Ok - Thank you

[wazza300]

Re: GA-Z68X-UD3P-B3 no deep power-saving

Just subtract what "normal" uses for CPU voltage from your stable 1.3v and enter that amount into dvid +0.0xxxx amount,then voltage will reduce at idle