Greetings,
I recently purchased a G41M-Combo motherboard and I am discovering that Vcore setting in BIOS does not work!
I have everything set to defaults for safety and only tweak the voltage settings in M.I.T.:
CPU Vcore: 1.250 (higher than 1.150 which is the default for my CPU)
CPU Termination: 1.200 (the default value)
DRAM Voltage: 1.500 (the default value)
I save and exit, then after rebooting I enter the PC Health Status to verify everything is ok.
The Vcore sensor reports a value near 1.250 so I assume that the Vcore is set ok.
HOWEVER, after I boot into Windows or Linux, I discover that my Vcore is back to its default value!
Which is a little less than 1.150.
I have tried with both the FA and FB BIOS revisions with the same results.
Any ideas as to why this is happening? What can be done to fix it?
Thanks!
I recently purchased a G41M-Combo motherboard and I am discovering that Vcore setting in BIOS does not work!
I have everything set to defaults for safety and only tweak the voltage settings in M.I.T.:
CPU Vcore: 1.250 (higher than 1.150 which is the default for my CPU)
CPU Termination: 1.200 (the default value)
DRAM Voltage: 1.500 (the default value)
I save and exit, then after rebooting I enter the PC Health Status to verify everything is ok.
The Vcore sensor reports a value near 1.250 so I assume that the Vcore is set ok.
HOWEVER, after I boot into Windows or Linux, I discover that my Vcore is back to its default value!
Which is a little less than 1.150.
I have tried with both the FA and FB BIOS revisions with the same results.
Any ideas as to why this is happening? What can be done to fix it?
Thanks!
Comment