PDA

View Full Version : Quick Epox 8kha+ Mounting Question



Flash
04-10-2002, 08:28 AM
For people who use the epox 8kha+ motherboard, did u use washers on the mobo? It looked to me like it was ok not to, so i didnt use washers ontop of the mobo.

Darthtanion
04-10-2002, 10:05 AM
If the system works fine, then you'll do well without the washers. These washers are normally a cloth/paper type material, and their purpose is to stop a possible short that can occur between the motherboard and the stand-off. Most modern mainboards will do fine without this addition, but I still use them (kinda old-fashioned I guess).

ReSpAwN DeMoN
04-12-2002, 06:07 AM
I put washers on the bottom of the board...there is not much contact area between the top of the board and the top of the screws...well atleast not compared to the stand off and the chassie