PDA

View Full Version : Is there a "burn in" Guide ?



DunpealHunter
08-11-2005, 01:39 AM
I am Buying the Mushkin DDR500 PC 4000 This Friday. I have read that they are better after burning in. So I am looking for a guide. Also, does anyone have any advice for cooling the ram? I saw in a article where a overclocker made a bracket out of a coat hanger and supported a 120mm fan over the ram. I have seen the Thermaltake active ram cooler, but it did not get impressive reviews. I do plan on overclocking the ram.

System
DFI Lanparty SLI DR
AMD San Diego 3700+
Mushkin DDR500 PC 4000, 1 Gig (2 x 512)
Antec Truepower 550 EPS
BFG 7800 XGT
Raptor 74 gig Master
WD 80 gig Slave

wayout44
08-11-2005, 03:12 AM
Use Prime95 for burning in but with that setup I doubt that you'll much of a chance at overclocking that memory.

DunpealHunter
08-11-2005, 03:44 AM
Why is that, What's wrong with my set up ?

Yawgm0th
08-11-2005, 03:52 AM
Agreed use Prime95 for burning in but use Memtest86+ (in my signature) as well, because it's a much better test of the RAM.

Is the RAM you got Mushkin Redline PC4000? That should overclock quite nicely along with the rest of your components. But as you mentioned, it can get quite hot and you may want to look into giving it active cooling. The method you described may be a good idea.

DunpealHunter
08-11-2005, 04:02 AM
whew!! I was a little worried after that last post. It is PC 4000. everything that I have read has led me to believe this is the best memory for my system. Noise is not a problem for me as my Antec case is rather quiet. I will put the fan with the highest cfm I can find.

Yawgm0th
08-11-2005, 04:07 AM
It is PC 4000.
Yeah, I got that the first time... Is it Mushkin Redline PC4000? Just any old PC4000 is nice, but Redline (or the identical OCZ VX) will make regular PC4000 look weak.

DunpealHunter
08-11-2005, 04:34 AM
I'm sorry, i did'nt catch that. It is the Redline series.


(http://www.newegg.com/Product/Product.asp?Item=N82E16820146392)

Yawgm0th
08-11-2005, 07:02 AM
Excellent, it will overclock quite nicely, but again, you will probably need active cooling, especially since that appears to be the older version without Mushkins new heatsink. If they sell it, though, you could buy a couple of them and replace the standard ones and see if that's enough, though I doubt you'd be able to get much past 3.2v without active cooling.

casecutter
08-11-2005, 07:42 AM
Use Prime95 for burning in but with that setup I doubt that you'll much of a chance at overclocking that memory.
Did you actually think before you wrote this?

That is excellent ram and it will get better with use. Follow Yawgm0th's suggestion and definitely get some good air cooling on it. Using coat hanger wire and a couple of 80MM or even 60MM fans will give you the cooling you need. The higher CFM fans would be better, but of course louder. I run my OCZ VX up to 3.5V with excellent cooling and it barely gets warm to the touch even when running 261MHz.

DunpealHunter
08-11-2005, 09:41 AM
I will follow Yawgmoth advice. I do need to know though. I read about the new heatsinks for the Mushkins coming out( dont remember where I read that dang article), but I do not know how to tell if it is the new or old or where to get the new ones. Any Ideas ?

Edit, found the article
http://www.google.com/url?sa=t&ct=res&cd=10&url=http%3A//www.legitreviews.com/article.php%3Faid%3D225&ei=8q_6Qof1D7rc4QH7z72LDg

Edit again, Now I need to buy the new Redline. Anyone know where I can get them ?

Darthtanion
08-11-2005, 10:17 AM
You don't need the new Redline modules... the memory is the same, just different heat spreaders with more surface area. If you're going to be using active cooling for the modules, then you'll be fine.

DunpealHunter
08-11-2005, 10:20 AM
Your probably right. I just wanted the lateset and greatest. They will porbably cost more too. I will get the ones that are available from newegg....:thumbsup:

casecutter
08-11-2005, 11:49 AM
You should give the sticks you have a chance before you replace them. Since overclocking is never guaranteed, you may have some really good sticks there, or average. If they don't overclock well, then sell them and look for newer. Otherwise, you may pass up on some really nice stuff that you already have.

DunpealHunter
08-11-2005, 12:39 PM
I am sorry, there is a misunderstanding. I do not currently have redlines. I am getting some this Friday, I currenty have Kingston value ram. DDR 400 PC 3200. I thought If I was going to get new ram ( Redline) I should get the new heatsink version

Yawgm0th
08-11-2005, 01:47 PM
There's a big misunderstanding...

I thought you had the Redline, and I was suggesting you get the new heatsinks for them seperately (assuming Mushkin sells them, and I'd bet they do), not replace them altogether. If you don't even have the RAM yet, then you should certainly go for the ones with the new heatsink.