Having just installed this new board, which is great, I cannot for the life of me get the damn thing to enter into suspend to Ram (All fans shut down, monitor off but ram “slow” refresh).
I had this enabled on my last board and used it extensively and so would not like to loose it!
I have discovered that the feature will not work in Jumper free mode and so have manually set the CPU Freq etc.
The PSU is a new Enermax and supplies at least 2 amps on the +5VSB so that should be no problem. But when I try to suspend it simply goes into “stand by” with the fans on and the monitor off!!
Can anyone give me a “walk through” as to the jumper settings and also the Bios settings needed to enable this? I did not even have the ACPI suspend feature in the bios until I was told of the Jumper Free aspect but that appears and is set to enable.
What am I doing wrong? Please, to have this board up ASAP would make my day!!
I had this enabled on my last board and used it extensively and so would not like to loose it!
I have discovered that the feature will not work in Jumper free mode and so have manually set the CPU Freq etc.
The PSU is a new Enermax and supplies at least 2 amps on the +5VSB so that should be no problem. But when I try to suspend it simply goes into “stand by” with the fans on and the monitor off!!
Can anyone give me a “walk through” as to the jumper settings and also the Bios settings needed to enable this? I did not even have the ACPI suspend feature in the bios until I was told of the Jumper Free aspect but that appears and is set to enable.
What am I doing wrong? Please, to have this board up ASAP would make my day!!
Comment