PDA

View Full Version : i want to unlock my bios...



sado0og
03-04-2009, 02:37 AM
i have boight hp pavilion dv5-1112ea amd turion mainboard is HP 3600 Version : 98.32 it's limited bios i want to tweak it how i can unlock it ?? is there a software can help

The Muncher
03-04-2009, 06:11 AM
You can't,the manufactor has it setup like that so you cant mess with the computer

sado0og
03-04-2009, 09:03 AM
my cousin did it with his hp laptop

how come ??

Darthtanion
03-04-2009, 12:26 PM
Why not ask your cousin? OEM motherboards are set up with a very limited BIOS so that it cuts down on their support costs.

trying
03-23-2009, 06:02 AM
might get some answers to bios questions on winbios there are other companies other there that will reflash bios but you might be taking a chance on destroying your board
I resently had to do a recover flash on my two laptops gateway and acer one
the acer was easy to get info on but the gateway well it was next to impossible to get info on even the bios version on the make was hard to get..
what are you trying to do?
mmtools is a tool used to edit bios but i have not used it nor am i going to use it untill i get some sound info on editing bios or purchase a back up bios before i start playing around wih the editor.

bnborg
04-22-2009, 08:36 AM
If you really want to get into it, go to The New Rebels Haven Forum!! (http://www.rebelshavenforum.com/sis-bin/ultimatebb.cgi).

clyd3robert
11-08-2009, 12:14 AM
How to unlock, hack, bypass, or crack a bios password

YouTube - How to unlock, hack, bypass, or crack a bios password (http://www.youtube.com/watch?v=Mns0Ngorzp8)

tony88
11-27-2009, 08:59 PM
This information is intended for experienced users. It is not intended for basic users, hackers, or computer thieves. Please do not try any of following procedures if you are not familiar with computer hardware. I'll not be responsible for the use or misuse of this information, including personal injury, loss of data or hardware damage. So use it at your own risk.
A. By Using the Motherboard Jumper:
In most motherboards CMOS battery is soldered, which makes it difficult to remove the battery. In this case we use another method.
Almost all motherboards contain a jumper that can clear all CMOS settings along with the BIOS password. The location of this jumper varies depending upon the motherboard brand. You should read your motherboard manual to check its location. If you don't have the manual then look for the jumpers near the CMOS battery. Most of the manufacturer label the jumper as CLR, CLEAR, CLEAR CMOS, etc.
When you find the jumper, look carefully. There will be 3 pins and the jumper will be joining the center pin to either left or right pin. What you need to do, is remove the jumper and join the center pin to the opposite pin. e.g. if the jumper joins center pin to left pin, then remove it and join center pin to right pin. Now wait for a few seconds and then again remove the jumper and join the center pin to left pin.
Make sure to turn the PC off before opening the cabinet and resetting the jumper.

B. By Using Software:

I have found that BIOS/CMOS Password Recovery Tool is the most effective.:
BIOS/CMOS Password Recovery Tool is a program that works instantly to remove any lost or forgotten BIOS/CMOS password. Simply boot your PC to DOS and execute the program, and get access to forgotten BIOS/CMOS passwords in just seconds
BIOS/CMOS Password Recovery Tool Service: BIOS Password Recovery - BIOS Password Recovery Tool - Remove or Clear BIOS Password (http://www.biospasswordrecovery.com/)

Psycho101
12-01-2009, 09:44 AM
In most motherboards CMOS battery is soldered,
Erm... no. I have yet to see a motherboard with a soldered down battery. Soldering a battery in any way can be pretty dangerous actually. Imagine a lithium button cell popping with the heat?

Every single board I have worked on in the last 14 years has a battery caddy. It's pretty simple to remove the battery if you wish. Exceptions are a couple of IBM laptops I've worked on. these had metal contacts stuck to them joined to a small lead and plug. The battery literally plugged into the board. It was still a standard CR2032 though.

Due to the complete inaccuracy of your post can we assume the reason for posting is to advertise the program you linked to? If so, this forum isn't a place to advertise and profit from.

Lovely World
01-30-2010, 02:26 AM
I resently had to do a recover flash on my two laptops gateway and acer one. The acer was easy to get info on but the gateway well it was next to impossible to get info on even the bios version on the make was hard to get..

bf2nut
07-12-2011, 03:43 AM
Why not ask your cousin? OEM motherboards are set up with a very limited BIOS so that it cuts down on their support costs.


"cuts down on their support costs." and noobs dont mess stuff up not meant for overclocking period.build a tower....lappys are slow out of the box.