hey guys,
i have a new LiteON 40x12x48 burner. i use Easy CD-DA Extractor 4.6.0 to rip cd's.
the prob is that i set the speed to maximum and the most it gets up to is about 4x. most of the time is around 2.5-3x. i have tried setting it to 12x, but that still doesnt go any faster than 4x.
DMA is enabled, Mode 2.
HDD - Slave on Primary controller
CDRW - Master on secondary controller
the hdd is on slave, because if i recall there was a problem detecting it if its on master.
my old kodak 8x-read, 4x-write, seemed to rip faster.
any ideas appreciated.
thanks
i have a new LiteON 40x12x48 burner. i use Easy CD-DA Extractor 4.6.0 to rip cd's.
the prob is that i set the speed to maximum and the most it gets up to is about 4x. most of the time is around 2.5-3x. i have tried setting it to 12x, but that still doesnt go any faster than 4x.
DMA is enabled, Mode 2.
HDD - Slave on Primary controller
CDRW - Master on secondary controller
the hdd is on slave, because if i recall there was a problem detecting it if its on master.
my old kodak 8x-read, 4x-write, seemed to rip faster.
any ideas appreciated.
thanks
Comment