If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
The Ti4600's are close to their peak but ya maybe lucky to get up to about a 10% o/c. Head over to The Guru of 3D and get either the GeForce Tweak Utility or the nVHardPage as these are both good utilities for o/c'n and tweakin' so long as ya not using WHQL drivers. They also have one of the best ranges of drivers available. ;)
<center>:cheers:</center>
The card i'm talking about is a Creative Gf4 Ti4600.
The only cooling on the card is the gpu fan, whitch btw is designed to blow air on the 4 memory chipsets as well as the gpu...
pcmkr[/size]] RivaTuner is also a good utility to try.
:wave:
The reason I left that out was because it's a little dated atm with support only up to 23.11 Dets officially where the other two support much higher. : peace2:
<center>:cheers:</center>
Ah so it has but ya have to go to the bottom of the page there to find that out which is stupid as most ppl will read the top and see the support list and bolt. :thumb:
<center>:cheers:</center>
Did some overclocking this morning with my vid card. Using RivaTuner and 30.30 drivers I got the core up to 327MHz and mem up to 724MHz. Gave me about 400-500 point increase in 3DMark score. I wrote down the score somewhere. It was around 11,450 I think. It's really hot in my room though. Bet I will get it higher in the winter ;)
Next time I'll get a screenshot so everyone believes me :laugh:
Comment