PDA

View Full Version : Loosing all data



almo
11-08-2002, 07:00 PM
After I have installed a Promise Ultra133 Tx2 adapter and connected my second 80 GB disk I am getting the following error: "Delayed write failed on E:\$MFT". After that my D: drive shows no data (means it is listed in MS-explorer, but when you cklick on it, no filesystem is found). As I found out, all data is still there, but has to be recovered with a prog.
What worries me is, will that ever happen to my main-drive? And what can be done to prevent those errors.

I dont know, if it has something to do with the errorcondition, but everytime this error occurres, my ADSL connection disconnected right before.

My present configuration can be found at:
http://www.mfu-wien.com/Temp/Gandalf_cfg.htm

If somebody needs the system-events-list in order to help, I can provide it.

Best regards
Almo

sKuLLsHoT
11-11-2002, 09:18 AM
did you change the drive from operating at ata100 on one chipset to ata133 on this new controller?

it might be that the minor timing differences between speeds/controllers has caused the drive to corrupt itself at certain points, maybe try using the drive in its old setup and see if the issue still exists..