If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
Just keep takin' it up in 5MHz steps till ya start to see glitches then drop back to the last setting. If ya happen to over step the mark and get a "Black Screen" just reset the PC and because Powerstrip was not shutdown properly it will offer ya to readjust the settings again before loading them again. It's always a good test between each adjustment for stability before goin' another step and to do this I run the 3DMark 2001SE at default settin's and watch it very carefully for visual faults or lockin' up the PC. ;)
<center>:cheers:</center>
Comment