Please report all spam threads, posts and suspicious members. We receive spam notifications and will take immediate action!
Page 2 of 2 FirstFirst 12
Results 11 to 11 of 11

Thread: Asrock extreme3 770 no video signal




  1. #11
    Reepur is offline Junior Member
    Join Date
    Apr 2012
    Location
    Carolina, USA
    Posts
    6

    Default Re: Asrock extreme3 770 no video signal

    I had the same issue with the x79 Extreme3 with 2 EVGA GTX 550ti's in SLI, worked awesome for a week.
    The one night.. "no video signal"
    Tried everything that you tried and gave up, go a RMA and when I was disassembling to get it ready to
    ship back, I found something that maybe causing it.

    Not sure if your board has the same PCIe graphic card retention slot, but on mine it does not have
    the typical spring loaded clip that locks when you press in your card. On mine, you have to physically
    "slide" a lock over the backside of the videocard to lock it in. As a result, my cards were not seated properly,
    they seemed to be, but it was a tight fit.
    I sent the board back anyway and have a Extreme6/GB coming to replace it.
    hope this helps.
    UPDATE: Found the issue was not the Mobo, I had the same issue with the hew board, Extreme6, so I started bare,
    Mobo, RAM, CPU, and Corsair H100, no HDD/SDD. Would not post but had power. Would stop @Dr.Debug code 60.
    So I pulled all the ram, and installed one stick at a time in the A1 slot. If good, it would reach code A6? looking for HDD.
    Found one bad, so left it out and was able to post/boot up, all is good now, waiting RMA on the one bad Stick.
    Wish the Extreme3 had Dr.debug, would have saved me alot of hassle.
    Last edited by Reepur; 05-07-2012 at 11:46 AM.
    Asrock Extreme6/GB w/ Intel i-3820@4.75
    16 GB Gskill RipjawsZ 2100 mhz
    Plextor 120 GB SSD/ WD 300 GB HDD
    2x EVGA GTX 550ti's in SLI
    Corsair H100 in a Rosewill Thor 2 case.
    Rosewill 1000w PSU

Page 2 of 2 FirstFirst 12

Thread Information

Users Browsing this Thread

There are currently 1 users browsing this thread. (0 members and 1 guests)

Tags for this Thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •