Please report all spam threads, posts and suspicious members. We receive spam notifications and will take immediate action!
Results 1 to 8 of 8

Thread: Couple of problems! Halp! D:




  1. #1
    prsc is offline Junior Member
    Join Date
    Aug 2012
    Location
    Canada
    Posts
    6

    Default Couple of problems! Halp! D:

    I just built my first PC and I've run into a couple problems I can't find any definitive answers to, here's my specs before we kick this off:

    OS: Vista 64-bit
    Processor: AMD Phenom II x4 Black Edition 3.4Mhz (stock fan)
    Gfx Card: Asus Geforce GTX 670
    Mobo: Asrock N68C-GS FX
    Memory: 16GB Corsair Vengeance
    Bios: 1.2


    Firstly my cpu fan is just going nuts, I can't get it to calm down unless I get OCtuner on and manually turn it down. Something must be wrong because when booting up it will start off at max RPM. Also when booting up it takes quite a while before it gets to the Asrock splash page, it roughly takes 5-6 seconds, initially when I first started trying to boot up my pc from the beginning I thought the display wasn't working at all, it's very odd that it takes this long.


    Next in line is instant boot. It was working at some point, but then when I tried to test it out it started saying the driver cannot load, the same thing happens when I try and use the Asrock driver/utilities disc that came with the mobo :s


    The restart button doesn't work, I fiddled with a myriad of combinations with the cables and the power button always worked but the restart doesn't; the layout on the system panel header in the manual is as such:

    Top pin 1 Pled+
    Bottom pin 1 HDled+

    Top pin 2 Pled-
    Bottom pin 2 HDled-

    Top pin 3 PwrBtn#
    Bottom pin 3 GND

    Top pin 4 GND
    Bottom pin 4 Rest#

    Top pin 5 Blank
    Bottom pin 5 Dummy


    Lastly, and here's the kicker, my CPU and Vcore settle at around 40-45C with a lowered voltage AND under clocking; all others are at 33-37C and this is during idle. I ran prime95 and the cpu/vcore temperature just kept climbing while everything else was pretty much staying the same. I get pretty average fps while playing games like 20-30 fps which is quite baffling because these specs are much much better than my old and seem to be pushing the same fps rates over a myriad of games.

    So someone please help! Pretty please!! D':

  2. #2
    prsc is offline Junior Member
    Join Date
    Aug 2012
    Location
    Canada
    Posts
    6

    Default Re: Couple of problems! Halp! D:

    No one has any ideas? D:

  3. #3
    Join Date
    Aug 2009
    Location
    Birmingham,Great Britain
    Posts
    9,250

    Default Re: Couple of problems! Halp! D:

    using latest bios? installed all the latest drivers from asrock website?
    Gigabyte z77x UP4-TH F11c Modded Bios
    Intel i7 3770k 24/7@4.8ghz 1.38v Turbo llc +0.165v dvid multithreading enabled
    Samsung Green(MV-3V4G3D/US) 8GB @2133mhz 9-10-10-21-1t 1.55v
    Thermalright Silver Arrow Cpu Cooler
    1xSamsung 840 pro 256 Gb SSD windows 8.1 pro 64bit
    1xSamsung f4 HD204UI 2tb hard drive Storage
    Powercolor 7970 3gb V3 @1150mhz core/1700mhz mem,1.150v Accelero aftermarket air cooler 55c max
    Razer Lycosa Keyboard
    Logitech X-530 5.1 Speakers
    Lite-On iHAS124-19 24x Sata DVDRW
    K-World Hybrid DVB-T 210SE Digital T.V Card
    L.G E2260V L.E.D 1920x1080 Monitor
    Xfx Pro 750w silver rated Psu 80+
    Fractal Arc Midi Case

    http://i38.tinypic.com/14myvfa.jpg x58 ud5 <=3.8ghz + 4.2ghz Overclock Template!!
    http://www.youtube.com/user/warren304#p/u Visit Me On Youtube

    Lots Of Gaming Videos With X58 Ud5 System And Gpu On My Youtube Channel!!
    Just Uploaded New Battlefield 4 Video!!!!!!!!!!!!!!!!!!!!!!

  4. #4
    prsc is offline Junior Member
    Join Date
    Aug 2012
    Location
    Canada
    Posts
    6

    Default Re: Couple of problems! Halp! D:

    1.2 is the latest BIOS that I recently installed 2 days ago, I thought I installed all the drivers the first time round when the disc worked, I'm going to download them all and install them again just to be sure.

  5. #5
    prsc is offline Junior Member
    Join Date
    Aug 2012
    Location
    Canada
    Posts
    6

    Default Re: Couple of problems! Halp! D:

    Ok so I re-installed all the drivers and utilities apart from the VGA driver and Instant Boot. The VGA driver says it cannot be installed after setup begins because it "cannot locate any drivers compatible with current hardware". Instant Boot just says the driver cannot be loaded, I've un-installed and re-installed it multiple times with no success, the Asrock disc suffers from the same problem as Instant Boot.

    Good news though, the restart button works :D everything else is the same though D:

  6. #6
    Ladislav Palocsanyi's Avatar
    Ladislav Palocsanyi is offline Junior Member
    Join Date
    Sep 2012
    Location
    Czech Republic
    Posts
    4

    Default Re: Couple of problems! Halp! D:

    got the same problem...everything worked fine then suddenly after restart Instant boot and AXTU cannot load drivers. tryed to reinstal all drivers and the problem persist :( both apps just wont load no idea why.

  7. #7
    parsec's Avatar
    parsec is offline Senior Member
    Join Date
    Jun 2012
    Location
    Third stone from the sun
    Posts
    4,824

    Default Re: Couple of problems! Halp! D:

    ASRock usually sets the CPU fan speed to Full On in the UEFI/BIOS, for safety purposes, or builders with not a lot of experience. In the Monitor screen of the UEFI, check that it is set to Auto or Manual, and then select the standard (base) speed from there. Same thing for the other fan headers.

    The instant boot issue, do you need to create a partition on a disk for that to work? On Intel boards that's required but I'm not sure how it works on AMD boards.

    Are you sure your CPU cooler is mounted correctly? If it's your first build, I would triple check that. What PC case are you using, and how many fans does it have and where are they mounted?

  8. #8
    Ladislav Palocsanyi's Avatar
    Ladislav Palocsanyi is offline Junior Member
    Join Date
    Sep 2012
    Location
    Czech Republic
    Posts
    4

    Default Re: Couple of problems! Halp! D:

    @ OP 40C on idle with Phenom II and stock cooler is pretty normal :( how high does it climb in Prime95 ?
    I had AMD Phenom II X2 555 Black Edition (unlocked 2 cores so it is : QuadCore AMD Phenom II X4 Black Edition B55 3200MHz overclocked to 3,8GHz) before the OC with those cores unlocked i had min 45C idle and over 60C full load the stock cooler is bad and super loud(on max RPM it sounds like chain saw), sadly you cant avoid high RPM, trust me i had to buy CM Hyper EVO 212+ due to how loud it was with stock cooler :( Bought CM cooler and now it is running on 3,8Ghz with less then 40C idle, never looked back since (got that cooler on my new i5 now aswell can only recommend)
    You can check if Quite and Cool is enabled in BIOS, but i believe it is.

    @ parsec :

    I have Intel board and the Instant Boot doesn't require special partition(it was enough to install the program on my 2nd HDD, so you are not wrong tho) it worked fine for almost 2 weeks then i cleaned my PC with RegCleaner and Instant boot and AXTU stoped working :( I have no idea what was removed, but it seems i cant make it work again. Windows restore wont let me choose older restore point then from yday(the day when it started failing, but 1 hour after) reinstalled all drivers and the programs(countless times) and it keeps popping error : Cannot load driver....

    I believe i will have to reinstall Windows to make it work again or live with "slow" boot times :( I am hopeless tbh, so if you guys have any tips i could try i would be happy.
    Last edited by Ladislav Palocsanyi; 09-18-2012 at 06:50 PM.

Thread Information

Users Browsing this Thread

There are currently 1 users browsing this thread. (0 members and 1 guests)

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •