Please report all spam threads, posts and suspicious members. We receive spam notifications and will take immediate action!
Results 1 to 4 of 4

Thread: Antec 1080 Coolin Config




  1. #1
    Join Date
    Dec 2002
    Posts
    124

    Default

    Hey, I've Just put together an Antec case with parts as listed in my Signature.

    I'm not too sure about what temps I should be getin for the case, but the CPU seems to hover around 46-49 Degrees.

    I've got 4 80mm Antec fans in the case + a Vulcano 11 on the CPU.

    Should I be getin lower temps, if so - How? :wow:
    ~AlthonXP T-Bred 2,600 @ 2305mhz~
    ~Epox 8RDA+~
    ~Hercules Radeon 9800XT 256mb~
    ~512 Corsair P3200 @ 6,2,2,2.0~
    ~WD1200JB HDD~
    ~Antec 1080 Plus~

  2. #2
    Join Date
    Nov 2001
    Location
    New England Highlands, Australia
    Posts
    21,907

    Default

    Well if ya have the front and side fans suckin' air into the case and the rear ones exhausting air then that's ok. The only other thing that I can think of is that ya have the spring clip back to front in the heatsink which is a commonly made mistake.

  3. #3
    Join Date
    Jun 2003
    Posts
    23

    Default

    i would have to agree with wiggo on this one because i did the same exact thing with the same exact volcano 11. the clip wasnt in the right place directly over the die so the temps were getting hot because of the poor contact. i have sence fixed that, and now i idle about 36 - 38 degrees. :)


    hope this helps

  4. #4
    Join Date
    Jun 2003
    Posts
    9

    Default

    make sure vcore is standard unless you need it higher, and maybe reapply thermal paste, you might not have used enough, or maybe too much.
    -=Gh3tt0PC=-

Thread Information

Users Browsing this Thread

There are currently 1 users browsing this thread. (0 members and 1 guests)

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •