Hi, I was wondering what configuration I need to use to get a stable 4.0 Ghz. I ran a 4.0 GHz setting which appeared to be stable, but after using linpack, it turns out that it only passed 4/5 tests. I tried tweaking it to fix the problem, but after increasing the voltages a bit on my vcore, my computer would not post, had continuous beeping for about 5 seconds and then shut down. After three occassions of that, it finally booted up, but my Bios had crashed and for some reason, my back up bios didn't kick in. The settings that I saved to the cmos were all gone as well, and I hadn't written any down. So, since I'm getting a new Xigmatek Dark Knight S1283 this weekend, I was wondering what a good set up might be. As of now, all settings are on stock and my computer set up is the same as what I placed on the first page. So if I could get some help, that'd be much obliged.