Please report all spam threads, posts and suspicious members. We receive spam notifications and will take immediate action!
Results 1 to 2 of 2

Thread: "Setup did not find any hard disk drives"




  1. #1
    Join Date
    Apr 2009
    Posts
    13

    Default "Setup did not find any hard disk drives"

    I've had my build for a week or 2 now, and i just got (2) 250gb seagate 7200.10's and trying to install them in raid0 (yes i know the "risk")

    i have been having problems all night and now have run into a wall..

    i've set my bios
    SATA RAID/AHCI Mode [RAID]

    Onboard SATA/IDE Device [Enabled]
    Onboard SATA/IDE Ctrl Mode [Enabled]

    i've created the Raid disk drive (Control + G at start-up)
    graid
    0stripe
    128kb
    500gb total

    i save everything
    run windows XP PRO
    insert floppy when asked
    installed drivers (ICH8R,ICH9R,ICH10R SATA RAID Controller)

    and then when it asks to install windows, it gives me the error that says

    Setup did not find any hard disk drives....

    the only thing im not sure on is in the instructions it says to install the raid volume by pressing CONTROL + I (after post memory and before o.s. boot)
    because it never showed it for me to press.. (which i tried anyways but nothing happened)

    thanks guys i am clueless of what is wrong..

  2. #2
    Lsdmeasap's Avatar
    Lsdmeasap is offline GIGABYTE Guru
    Join Date
    Jan 2008
    Location
    PCB Island
    Posts
    25,940

    Default Re: "Setup did not find any hard disk drives"

    If we knew what board you had that would be a little better for us to advise, but just sounds like you either are using the wrong ports and or also looks like you are setting the wrong settings per the Intel ports you should be using

    You need to connect your Hard drives to the first two yellow ports (SATA2_0 and SATA2_1) NOT GSATA. Then on reboot you can use Control + I before the IRQ Screen

    Then you will need to set these settings >>>

    Integrated Peripherals

    Intel Controller (Yellow Ports)
    SATA RAID/AHCI Mode (Intel ICH10R Southbridge) ............. RAID
    SATA Port0-3 Native Mode ................................... Enabled (or Disabled, both will work)

    Gigabyte/J.Micron Controller (Purple Ports) << These can be left enabled, disabled, or set to anything depending on if you are using IDE Devices or the Purple Ports (Again For OS RAID Use the Yellow ones)
    Onboard SATA/IDE Device (GIGABYTE SATA2 Chip) ............. Enabled/Disabled
    Onboard SATA/IDE Ctrl Mode (GIGABYTE SATA2 Chip) ........... IDE/IDE_RAID/AHCI

Thread Information

Users Browsing this Thread

There are currently 1 users browsing this thread. (0 members and 1 guests)

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •