Please report all spam threads, posts and suspicious members. We receive spam notifications and will take immediate action!
Page 2 of 2 FirstFirst 12
Results 11 to 13 of 13

Thread: GA-X58A-UD5 (rev 2.0) winxp x64 won`t install with ahci




  1. #11
    Lsdmeasap's Avatar
    Lsdmeasap is offline GIGABYTE Guru
    Join Date
    Jan 2008
    Location
    PCB Island
    Posts
    25,940

    Default Re: GA-X58A-UD5 (rev 2.0) winxp x64 won`t install with ahci

    If you still have no luck, try slipstreaming the AHCI Driver instead of F6 install, that may help.

    Or you could always just use RAID since you said that works, any Non-RAID Disk will just be Non-Member and will be ran in AHCI mode.

  2. #12
    Join Date
    Mar 2011
    Location
    usa
    Posts
    6

    Default Re: GA-X58A-UD5 (rev 2.0) winxp x64 won`t install with ahci

    Thx again to everyone who tried to help me but i`ve tried all the suggestions & still not working :( I`ve decided to give up & leave it set on raid as that works fine other than i think the boot-time may be a few secs longer.

  3. #13
    Lsdmeasap's Avatar
    Lsdmeasap is offline GIGABYTE Guru
    Join Date
    Jan 2008
    Location
    PCB Island
    Posts
    25,940

    Default Re: GA-X58A-UD5 (rev 2.0) winxp x64 won`t install with ahci

    RAID and AHCI boot times would be the same since they both load the AHCI/RAID BIOS screens, so you are good to go really.

    I use RAID on single drive setups always, and I actually prefer it and think it performs a hair better that way too.

Page 2 of 2 FirstFirst 12

Thread Information

Users Browsing this Thread

There are currently 1 users browsing this thread. (0 members and 1 guests)

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •