Hi,
I've just purchased a shuttle SP35P2 Pro with:
Intel core 2 quad Q6600
2x 1GB Corsair XMS2 DHX PC6400 RAM
Asus 512MB 8800GTS PCI-E
500GB Western Digital S-ATA HD
I've fitted all the components in and have been very careful with the installation.
I've plugged the power cable in and connected up the monitor.
I turned it on, and I can hear all the fans spinning and the lights turn on, but once its done its test, it just turns itself off.
I thought i'd put the RAM sticks in the wrong slot, was using DIMM 1 and DIMM 3, but the setup picture guide shows it using DIMM 2 and DIMM 4 so I did that instead.
After putting it back together, I reset CMOS and powered it on then same thing happens. Can anyone please shed some light on the situation.
THanks
I've just purchased a shuttle SP35P2 Pro with:
Intel core 2 quad Q6600
2x 1GB Corsair XMS2 DHX PC6400 RAM
Asus 512MB 8800GTS PCI-E
500GB Western Digital S-ATA HD
I've fitted all the components in and have been very careful with the installation.
I've plugged the power cable in and connected up the monitor.
I turned it on, and I can hear all the fans spinning and the lights turn on, but once its done its test, it just turns itself off.
I thought i'd put the RAM sticks in the wrong slot, was using DIMM 1 and DIMM 3, but the setup picture guide shows it using DIMM 2 and DIMM 4 so I did that instead.
After putting it back together, I reset CMOS and powered it on then same thing happens. Can anyone please shed some light on the situation.
THanks
Comment