Well I have noticed this with the latest version of ET6 and a couple of the past version. Not sure if its ET6 problem or bios problem but if you set 1.32 vtt in bios boot into windows and look at ET6 it will show 1.30. If you set 1.32 in ET6 and press the Set button it will switch back to 1.30. It only seems to do it with this voltage everything else seems fine.
I know your not supposed to set voltages in windows but if you need to bump vcore 1 notch or mch one notch no problem but if your at the 1.32 vtt and change those voltages and ET6 shows 1.30. Once you hit set it will set vtt to 1.30. So if you were stable at 1.32 to a point you wont be stable to that point again since ET6 set vtt to 1.30.
Just food for thought and to see if anyone has notice this.
I know your not supposed to set voltages in windows but if you need to bump vcore 1 notch or mch one notch no problem but if your at the 1.32 vtt and change those voltages and ET6 shows 1.30. Once you hit set it will set vtt to 1.30. So if you were stable at 1.32 to a point you wont be stable to that point again since ET6 set vtt to 1.30.
Just food for thought and to see if anyone has notice this.
Comment