Hello,
So my first rig consitists of a ga-ep45-ud3p rev. 1.6, a 750hx psu,
currently a e8400, about 2 b upgraded 2 a q9550, and now 8 gigs of
OCZ2RPR10664GK, a 1tb wd hard drive and a brand new OCZSSD2-2VTX40G. I have 2
problems. #1 when I got my second kit of OCZ2RPR10664GK, I have had to lower my
oc from 4.04ghz down to stock because no matter how much voltage i give 2 the
northbridge and 2 the ram (1.32 volts and 2.2) it either gets into an endless
reboot loop (at my origanal speed of 4ghz) or it freezes in boot or gets an
error in windows that says it will shutdown in 1 minute and areo looks like the
basic theme with the grayish blue colors. I know that running 8 gigs stress the
northbridge but idk how to make it work. im gonna run memtest with just the 2
new sticks soon to c if the sticks r bad. #2 my new ssd slows down the sata
bios detection. It hangs while its detecting the ssd then gives the message
smart command failed. I have the FE bios and the 1.11 firmware on the drive. I
have my 1tb in the 1st sata port till I install windows 7 on the ssd and then
the ssd then the dvd drive. I tried downgrading the firmware of the ssd but it wont let me. Thank you.
So my first rig consitists of a ga-ep45-ud3p rev. 1.6, a 750hx psu,
currently a e8400, about 2 b upgraded 2 a q9550, and now 8 gigs of
OCZ2RPR10664GK, a 1tb wd hard drive and a brand new OCZSSD2-2VTX40G. I have 2
problems. #1 when I got my second kit of OCZ2RPR10664GK, I have had to lower my
oc from 4.04ghz down to stock because no matter how much voltage i give 2 the
northbridge and 2 the ram (1.32 volts and 2.2) it either gets into an endless
reboot loop (at my origanal speed of 4ghz) or it freezes in boot or gets an
error in windows that says it will shutdown in 1 minute and areo looks like the
basic theme with the grayish blue colors. I know that running 8 gigs stress the
northbridge but idk how to make it work. im gonna run memtest with just the 2
new sticks soon to c if the sticks r bad. #2 my new ssd slows down the sata
bios detection. It hangs while its detecting the ssd then gives the message
smart command failed. I have the FE bios and the 1.11 firmware on the drive. I
have my 1tb in the 1st sata port till I install windows 7 on the ssd and then
the ssd then the dvd drive. I tried downgrading the firmware of the ssd but it wont let me. Thank you.
Comment