Hi All:
On Gigabyte`s website in the specification notes for my soon to arrive GA-970A-UD3 board, it says to "(Note 4) Be sure to connect your USB device(s) to the USB 2.0/1.1 ports before the USB 3.0 driver is installed.". Does this mean I should find a USB device for each and every port on the MB so that the drivers will detect all ports or is only 1 port enough or what? I know it is perfectly clear to whomever wrote the note and I appreciate the heads up but I am confused nonetheless. Thanks for any help ya`ll can give. I searched but didn`t find a thread for this question even though there are probably dozens.
Also, this leads me to believe there is the possibility I must keep some ports USB2 reserved. Is this true or will the new drivers take care of this and let me use USB2 stuff in any port?
plain
On Gigabyte`s website in the specification notes for my soon to arrive GA-970A-UD3 board, it says to "(Note 4) Be sure to connect your USB device(s) to the USB 2.0/1.1 ports before the USB 3.0 driver is installed.". Does this mean I should find a USB device for each and every port on the MB so that the drivers will detect all ports or is only 1 port enough or what? I know it is perfectly clear to whomever wrote the note and I appreciate the heads up but I am confused nonetheless. Thanks for any help ya`ll can give. I searched but didn`t find a thread for this question even though there are probably dozens.
Also, this leads me to believe there is the possibility I must keep some ports USB2 reserved. Is this true or will the new drivers take care of this and let me use USB2 stuff in any port?
plain
Comment