If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
LLC is Load Line Calibration, it stops your Vcore from having such a large drop between Idle voltage and Load Voltages.
This is not the cause of your issues.
BSOD 101 is vcore most often, sounds like you need to raise this a bit. Or enable LLC if you are not already using it, and then if you still get the 101 BSOD try more Vcore
0X00000050 << Incorrect Memory Timing/Freq or Uncore Multi
0X00000124 << Incorrect QPI/Vtt Voltage (To Much/Not Enough)
0X00000101 << Not enough Vcore Voltage
Comment